LY1BWB APRS Track Direct

Mano pozicija Apie ☰

reset

SP5UID-2 Telemetrija

This is the latest recevied telemetry packets stored in our database for station/object SP5UID-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1749357564	25 Count	1045 Count
1749357278	1 Count	57 Count
1749356376	0 Count	29 Count
1749356363	24 Count	996 Count
1749355475	27 Count	1003 Count
1749355162	23 Count	959 Count
1749354574	26 Count	972 Count
1749353961	22 Count	921 Count
1749353673	25 Count	943 Count
1749352771	24 Count	918 Count
1749352760	21 Count	879 Count
1749351870	23 Count	891 Count
1749351559	20 Count	843 Count
1749350969	22 Count	861 Count
1749350358	19 Count	813 Count
1749350068	21 Count	839 Count
1749349167	20 Count	813 Count
1749349157	18 Count	768 Count
1749348266	19 Count	778 Count
1749347956	17 Count	732 Count
1749347365	18 Count	757 Count
1749346755	16 Count	702 Count
1749346464	17 Count	724 Count
1749345563	16 Count	693 Count
1749345554	15 Count	659 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)