LY1BWB APRS Track Direct

Mano pozicija Apie ☰

reset

SQ2LXR-10 Telemetrija

This is the latest recevied telemetry packets stored in our database for station/object SQ2LXR-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1762281100	126 Count	498 Count	100 Count
1762279295	125 Count	498 Count	100 Count
1762268917	118 Count	498 Count	100 Count
1762268839	117 Count	498 Count	100 Count
1762268810	116 Count	498 Count	100 Count
1762266773	87 Count	437 Count	77 Count
1762264972	77 Count	394 Count	68 Count
1762263171	72 Count	359 Count	64 Count
1762261370	66 Count	322 Count	59 Count
1762259570	58 Count	277 Count	52 Count
1762257769	53 Count	250 Count	48 Count
1762255968	25 Count	161 Count	21 Count
1762254176	17 Count	127 Count	14 Count
1762252376	12 Count	98 Count	10 Count
1762250575	7 Count	65 Count	6 Count
1762248774	3 Count	30 Count	3 Count
1762246973	129 Count	1048 Count	91 Count
1762245173	113 Count	984 Count	76 Count
1762243372	110 Count	958 Count	74 Count
1762241571	107 Count	929 Count	72 Count
1762239770	104 Count	900 Count	70 Count
1762237970	101 Count	866 Count	68 Count
1762236169	98 Count	833 Count	66 Count
1762234368	94 Count	798 Count	63 Count
1762232576	91 Count	765 Count	61 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)