LY1BWB APRS Track Direct

Mano pozicija Apie ☰

reset

SQ4VK-10 Telemetrija

This is the latest recevied telemetry packets stored in our database for station/object SQ4VK-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1765140136	354 Count	103 Count	59 Count
1765139235	347 Count	102 Count	58 Count
1765138334	341 Count	101 Count	58 Count
1765137451	332 Count	98 Count	56 Count
1765136550	325 Count	95 Count	54 Count
1765116734	136 Count	32 Count	8 Count
1765115850	127 Count	30 Count	7 Count
1765114950	121 Count	30 Count	7 Count
1765114049	114 Count	27 Count	6 Count
1765113148	107 Count	26 Count	6 Count
1765112247	100 Count	25 Count	6 Count
1765111347	94 Count	24 Count	5 Count
1765110446	87 Count	24 Count	5 Count
1765109545	81 Count	22 Count	5 Count
1765108645	74 Count	21 Count	5 Count
1765107744	68 Count	21 Count	5 Count
1765106843	60 Count	19 Count	4 Count
1765105942	55 Count	16 Count	4 Count
1765105042	47 Count	13 Count	4 Count
1765104140	41 Count	13 Count	4 Count
1765103239	35 Count	11 Count	4 Count
1765102339	29 Count	9 Count	4 Count
1765101438	21 Count	8 Count	3 Count
1765100537	14 Count	6 Count	2 Count
1765099637	6 Count	2 Count	1 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)