LY1BWB APRS Track Direct

Mano pozicija Apie ☰

reset

SP5UID-2 Telemetrija

This is the latest recevied telemetry packets stored in our database for station/object SP5UID-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1748740167	0 Count	56 Count
1748739836	1 Count	99 Count
1748739265	22 Count	1028 Count
1748738635	0 Count	0 Count
1748737479	9 Count	966 Count
1748737463	20 Count	942 Count
1748736561	19 Count	898 Count
1748736277	8 Count	881 Count
1748735660	18 Count	848 Count
1748735076	7 Count	788 Count
1748734759	17 Count	788 Count
1748733875	6 Count	659 Count
1748733857	16 Count	722 Count
1748732956	15 Count	695 Count
1748732674	5 Count	565 Count
1748732055	14 Count	643 Count
1748731472	4 Count	474 Count
1748731154	13 Count	601 Count
1748730270	3 Count	384 Count
1748730252	12 Count	564 Count
1748729351	11 Count	548 Count
1748729069	2 Count	286 Count
1748728450	10 Count	524 Count
1748727868	1 Count	188 Count
1748727549	9 Count	505 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)