LY1BWB APRS Track Direct

Mano pozicija Apie ☰

reset

SQ2CPA-1 Telemetrija

This is the latest recevied telemetry packets stored in our database for station/object SQ2CPA-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1756622944	37 Count	724 Count
1756621144	36 Count	689 Count
1756619350	35 Count	676 Count
1756617549	34 Count	663 Count
1756615748	33 Count	650 Count
1756613948	32 Count	639 Count
1756612147	31 Count	628 Count
1756610346	30 Count	617 Count
1756608545	29 Count	600 Count
1756606745	28 Count	585 Count
1756604944	27 Count	572 Count
1756603143	26 Count	559 Count
1756601342	25 Count	549 Count
1756599542	24 Count	542 Count
1756597749	23 Count	534 Count
1756595949	22 Count	522 Count
1756594148	21 Count	509 Count
1756592347	20 Count	497 Count
1756590547	19 Count	483 Count
1756588746	18 Count	471 Count
1756586945	17 Count	458 Count
1756585144	16 Count	428 Count
1756583344	15 Count	397 Count
1756581543	14 Count	386 Count
1756579742	13 Count	373 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)