LY1BWB APRS Track Direct

Mano pozicija Apie ☰

reset

SQ2MO Telemetrija

This is the latest recevied telemetry packets stored in our database for station/object SQ2MO. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1755194382	149 Count	678 Count	53 Count
1755193781	147 Count	670 Count	53 Count
1755193180	145 Count	664 Count	53 Count
1755192579	143 Count	653 Count	53 Count
1755191978	140 Count	638 Count	52 Count
1755191378	136 Count	625 Count	51 Count
1755190777	133 Count	613 Count	51 Count
1755190175	130 Count	595 Count	50 Count
1755189575	127 Count	578 Count	49 Count
1755188372	110 Count	505 Count	36 Count
1755187771	91 Count	459 Count	19 Count
1755187171	80 Count	429 Count	11 Count
1755186570	78 Count	419 Count	11 Count
1755185969	76 Count	410 Count	11 Count
1755185368	74 Count	396 Count	11 Count
1755184768	71 Count	386 Count	10 Count
1755184167	64 Count	377 Count	10 Count
1755183566	61 Count	362 Count	10 Count
1755182965	57 Count	344 Count	8 Count
1755182365	55 Count	337 Count	8 Count
1755181163	51 Count	312 Count	8 Count
1755180563	49 Count	302 Count	8 Count
1755180002	38 Count	269 Count	6 Count
1755179402	36 Count	248 Count	5 Count
1755178801	31 Count	231 Count	1 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)