LY1BWB APRS Track Direct

Mano pozicija Apie ☰

reset

SQ2SIX-10 Telemetrija

This is the latest recevied telemetry packets stored in our database for station/object SQ2SIX-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1762268610	18 Count	381 Count	18 Count
1762268010	18 Count	378 Count	18 Count
1762267403	18 Count	375 Count	18 Count
1762266803	18 Count	373 Count	18 Count
1762266203	18 Count	371 Count	18 Count
1762265603	18 Count	369 Count	18 Count
1762265003	18 Count	367 Count	18 Count
1762264403	18 Count	365 Count	18 Count
1762263802	18 Count	363 Count	18 Count
1762263202	18 Count	361 Count	18 Count
1762262602	18 Count	359 Count	18 Count
1762262002	18 Count	357 Count	18 Count
1762261402	18 Count	355 Count	18 Count
1762260802	18 Count	352 Count	18 Count
1762260202	18 Count	350 Count	18 Count
1762259601	18 Count	348 Count	18 Count
1762259001	18 Count	346 Count	18 Count
1762258401	18 Count	344 Count	18 Count
1762257801	10 Count	323 Count	10 Count
1762257201	10 Count	305 Count	10 Count
1762256601	10 Count	295 Count	10 Count
1762256001	10 Count	293 Count	10 Count
1762255401	10 Count	291 Count	10 Count
1762254801	10 Count	289 Count	10 Count
1762254201	10 Count	287 Count	10 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)