LY1BWB APRS Track Direct

Mano pozicija Apie ☰

reset

SR2SAT-10 Telemetrija

This is the latest recevied telemetry packets stored in our database for station/object SR2SAT-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1754073581	104 Count	390 Count	70 Count
1754071780	100 Count	380 Count	67 Count
1754069979	96 Count	370 Count	64 Count
1754068179	92 Count	362 Count	61 Count
1754066378	87 Count	353 Count	57 Count
1754064577	83 Count	344 Count	54 Count
1754060976	65 Count	310 Count	38 Count
1754059176	50 Count	280 Count	24 Count
1754057382	43 Count	273 Count	22 Count
1754053780	39 Count	250 Count	20 Count
1754051980	37 Count	244 Count	19 Count
1754050179	34 Count	233 Count	17 Count
1754048379	31 Count	221 Count	15 Count
1754046578	29 Count	174 Count	14 Count
1754044777	27 Count	159 Count	13 Count
1754042977	25 Count	150 Count	12 Count
1754041176	23 Count	139 Count	11 Count
1754039375	20 Count	128 Count	9 Count
1754037575	18 Count	118 Count	8 Count
1754035781	12 Count	106 Count	7 Count
1754032179	8 Count	85 Count	5 Count
1754030379	5 Count	79 Count	3 Count
1754028578	3 Count	71 Count	2 Count
1754026778	1 Count	40 Count	1 Count
1754024977	149 Count	1005 Count	84 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)