LY1BWB APRS Track Direct

Mano pozicija Apie ☰

reset

SP2HCA-10 Telemetrija

This is the latest recevied telemetry packets stored in our database for station/object SP2HCA-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1746119101	30 Count	335 Count	19 Count
1746117301	23 Count	288 Count	13 Count
1746115500	20 Count	259 Count	11 Count
1746113699	17 Count	226 Count	9 Count
1746111898	14 Count	197 Count	7 Count
1746110097	11 Count	158 Count	5 Count
1746108296	8 Count	104 Count	3 Count
1746106495	4 Count	0 Count	0 Count
1746104703	113 Count	956 Count	80 Count
1746102903	110 Count	917 Count	78 Count
1746101101	107 Count	885 Count	76 Count
1746099301	104 Count	850 Count	74 Count
1746097500	101 Count	819 Count	72 Count
1746095699	98 Count	783 Count	70 Count
1746093898	95 Count	756 Count	68 Count
1746092098	91 Count	719 Count	65 Count
1746090297	87 Count	667 Count	62 Count
1746088496	83 Count	622 Count	59 Count
1746086695	79 Count	570 Count	56 Count
1746084894	74 Count	531 Count	52 Count
1746083102	66 Count	496 Count	49 Count
1746081302	61 Count	460 Count	45 Count
1746079501	57 Count	421 Count	42 Count
1746077700	53 Count	378 Count	39 Count
1746075899	49 Count	349 Count	36 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)