LY1BWB APRS Track Direct

Mano pozicija Apie ☰

reset

SR2BC-10 Telemetrija

This is the latest recevied telemetry packets stored in our database for station/object SR2BC-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1741857324	29 Count	782 Count	16 Count
1741855523	27 Count	686 Count	15 Count
1741853140	25 Count	546 Count	14 Count
1741851339	22 Count	395 Count	12 Count
1741849538	20 Count	301 Count	11 Count
1741847737	18 Count	234 Count	10 Count
1741845936	16 Count	208 Count	9 Count
1741844136	14 Count	177 Count	8 Count
1741842334	11 Count	144 Count	6 Count
1741840534	9 Count	118 Count	5 Count
1741838733	7 Count	93 Count	4 Count
1741836932	5 Count	66 Count	3 Count
1741835131	3 Count	32 Count	2 Count
1741833330	0 Count	0 Count	0 Count
1741829735	22 Count	1032 Count	12 Count
1741827934	20 Count	944 Count	11 Count
1741826133	18 Count	827 Count	10 Count
1741824332	15 Count	712 Count	8 Count
1741822532	13 Count	596 Count	7 Count
1741820731	11 Count	490 Count	6 Count
1741818930	9 Count	375 Count	5 Count
1741817129	7 Count	272 Count	4 Count
1741815329	4 Count	178 Count	2 Count
1741811726	0 Count	0 Count	0 Count
1741810071	3 Count	174 Count	2 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)