LY1BWB APRS Track Direct

Mano pozicija Apie ☰

reset

SQ4HSE-10 Telemetrija

This is the latest recevied telemetry packets stored in our database for station/object SQ4HSE-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1760651388	780 Count	414 Count	296 Count
1760647787	777 Count	411 Count	294 Count
1760640585	771 Count	405 Count	290 Count
1760636984	768 Count	402 Count	288 Count
1760633383	765 Count	399 Count	286 Count
1760629782	762 Count	396 Count	284 Count
1760626182	759 Count	393 Count	282 Count
1760622581	756 Count	390 Count	280 Count
1760618979	753 Count	387 Count	278 Count
1760615379	750 Count	384 Count	276 Count
1760611778	747 Count	381 Count	274 Count
1760608177	744 Count	378 Count	272 Count
1760604575	741 Count	375 Count	270 Count
1760600975	738 Count	372 Count	268 Count
1760597373	735 Count	369 Count	266 Count
1760593772	732 Count	367 Count	264 Count
1760590170	729 Count	364 Count	262 Count
1760586570	726 Count	361 Count	260 Count
1760582968	723 Count	358 Count	258 Count
1760579366	720 Count	355 Count	256 Count
1760575765	717 Count	352 Count	254 Count
1760572164	714 Count	349 Count	252 Count
1760568563	711 Count	346 Count	250 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)