LY1BWB APRS Track Direct

Mano pozicija Apie ☰

reset

SP2OSA Telemetrija

This is the latest recevied telemetry packets stored in our database for station/object SP2OSA. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1753581663	48 Count	801 Count	31 Count
1753579863	45 Count	641 Count	29 Count
1753578062	42 Count	526 Count	27 Count
1753576261	39 Count	374 Count	25 Count
1753574460	36 Count	298 Count	23 Count
1753572660	33 Count	257 Count	21 Count
1753570867	26 Count	227 Count	19 Count
1753569066	23 Count	198 Count	17 Count
1753567265	17 Count	167 Count	12 Count
1753565465	14 Count	143 Count	10 Count
1753563664	11 Count	113 Count	8 Count
1753561863	8 Count	81 Count	6 Count
1753560063	5 Count	56 Count	4 Count
1753558261	2 Count	28 Count	2 Count
1753556461	172 Count	1076 Count	131 Count
1753554660	165 Count	989 Count	125 Count
1753552859	162 Count	967 Count	123 Count
1753551059	159 Count	946 Count	121 Count
1753549265	152 Count	924 Count	119 Count
1753547465	149 Count	897 Count	117 Count
1753545664	143 Count	859 Count	112 Count
1753543863	140 Count	840 Count	110 Count
1753542063	118 Count	783 Count	89 Count
1753540262	115 Count	749 Count	87 Count
1753538462	112 Count	730 Count	85 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)