LY1BWB APRS Track Direct

Mano pozicija Apie ☰

reset

SR2ST-11 Telemetrija

This is the latest recevied telemetry packets stored in our database for station/object SR2ST-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1761775394	640 Count	583 Count	583 Count
1761773713	613 Count	557 Count	557 Count
1761773649	608 Count	557 Count	557 Count
1761771968	599 Count	549 Count	549 Count
1761770287	573 Count	524 Count	524 Count
1761768606	555 Count	507 Count	507 Count
1761767178	550 Count	507 Count	507 Count
1761765497	548 Count	506 Count	506 Count
1761763816	546 Count	505 Count	505 Count
1761762135	544 Count	504 Count	504 Count
1761760454	542 Count	503 Count	503 Count
1761758772	540 Count	502 Count	502 Count
1761757091	538 Count	501 Count	501 Count
1761755410	536 Count	500 Count	500 Count
1761753729	523 Count	488 Count	488 Count
1761752048	489 Count	455 Count	455 Count
1761750367	454 Count	421 Count	421 Count
1761748686	413 Count	381 Count	381 Count
1761747005	406 Count	375 Count	375 Count
1761740349	301 Count	278 Count	278 Count
1761738668	280 Count	258 Count	258 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)