LY1BWB APRS Track Direct

Mano pozicija Apie ☰

reset

SR2ZXT-10 Telemetrija

This is the latest recevied telemetry packets stored in our database for station/object SR2ZXT-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1753619648	94 Count	647 Count	73 Count
1753617847	89 Count	608 Count	69 Count
1753616046	85 Count	576 Count	66 Count
1753614246	80 Count	549 Count	62 Count
1753612445	76 Count	521 Count	59 Count
1753610644	71 Count	486 Count	55 Count
1753608844	67 Count	460 Count	52 Count
1753607043	62 Count	431 Count	48 Count
1753605242	58 Count	410 Count	45 Count
1753603442	53 Count	375 Count	41 Count
1753601641	49 Count	342 Count	38 Count
1753599840	45 Count	309 Count	35 Count
1753592277	44 Count	309 Count	35 Count
1753590476	40 Count	279 Count	32 Count
1753588682	35 Count	247 Count	28 Count
1753586881	31 Count	224 Count	25 Count
1753585081	26 Count	188 Count	21 Count
1753583280	22 Count	157 Count	18 Count
1753581479	17 Count	125 Count	14 Count
1753579679	13 Count	92 Count	11 Count
1753577878	8 Count	63 Count	7 Count
1753576078	4 Count	31 Count	4 Count
1753574277	181 Count	1024 Count	154 Count
1753572476	177 Count	993 Count	151 Count
1753570676	172 Count	955 Count	147 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)