LY1BWB APRS Track Direct

Mano pozicija Apie ☰

reset

SP2PA-10 Telemetrija

This is the latest recevied telemetry packets stored in our database for station/object SP2PA-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1764475799	193 Count	603 Count	70 Count
1764473998	191 Count	600 Count	69 Count
1764472197	188 Count	596 Count	67 Count
1764470396	187 Count	594 Count	67 Count
1764468595	184 Count	590 Count	65 Count
1764466794	183 Count	588 Count	65 Count
1764464993	180 Count	584 Count	63 Count
1764463192	178 Count	581 Count	62 Count
1764461404	175 Count	577 Count	60 Count
1764459603	173 Count	574 Count	59 Count
1764457802	170 Count	570 Count	57 Count
1764456001	167 Count	567 Count	55 Count
1764454200	166 Count	566 Count	55 Count
1764452399	165 Count	566 Count	55 Count
1764450598	164 Count	566 Count	55 Count
1764448797	161 Count	564 Count	53 Count
1764446996	159 Count	563 Count	52 Count
1764445195	158 Count	563 Count	52 Count
1764443394	157 Count	561 Count	52 Count
1764441593	154 Count	558 Count	50 Count
1764440683	153 Count	558 Count	50 Count
1764438882	150 Count	556 Count	48 Count
1764437081	148 Count	553 Count	47 Count
1764435280	147 Count	553 Count	47 Count
1764433479	145 Count	545 Count	46 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)