LY1BWB APRS Track Direct

Mano pozicija Apie ☰

reset

SQ2WSZ-1 Telemetrija

This is the latest recevied telemetry packets stored in our database for station/object SQ2WSZ-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1757159678	209 Count	602 Count	47 Count
1757158794	199 Count	582 Count	42 Count
1757157893	195 Count	573 Count	39 Count
1757156992	193 Count	558 Count	38 Count
1757156091	191 Count	551 Count	37 Count
1757155190	189 Count	544 Count	36 Count
1757154289	187 Count	539 Count	35 Count
1757153389	181 Count	527 Count	30 Count
1757152488	175 Count	516 Count	25 Count
1757151587	170 Count	504 Count	21 Count
1757150686	168 Count	493 Count	20 Count
1757148885	164 Count	488 Count	19 Count
1757147984	160 Count	480 Count	16 Count
1757147083	147 Count	464 Count	4 Count
1757145282	145 Count	463 Count	4 Count
1757144381	144 Count	458 Count	4 Count
1757141680	141 Count	455 Count	4 Count
1757140779	140 Count	451 Count	4 Count
1757139878	139 Count	449 Count	4 Count
1757138978	138 Count	446 Count	4 Count
1757138077	137 Count	446 Count	4 Count
1757137203	132 Count	440 Count	4 Count
1757136295	131 Count	434 Count	4 Count
1757135394	130 Count	427 Count	4 Count
1757134493	129 Count	427 Count	4 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)