LY1BWB APRS Track Direct

Mano pozicija Apie ☰

reset

SR2JP-10 Telemetrija

This is the latest recevied telemetry packets stored in our database for station/object SR2JP-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1756541239	82 Count	468 Count	20 Count
1756539558	71 Count	414 Count	17 Count
1756537877	63 Count	341 Count	16 Count
1756536196	52 Count	269 Count	13 Count
1756534516	46 Count	218 Count	12 Count
1756532835	35 Count	173 Count	9 Count
1756531154	20 Count	104 Count	5 Count
1756529473	11 Count	51 Count	3 Count
1756527792	258 Count	1028 Count	63 Count
1756526112	249 Count	984 Count	61 Count
1756524431	242 Count	936 Count	60 Count
1756522999	229 Count	894 Count	57 Count
1756521318	217 Count	834 Count	54 Count
1756519637	206 Count	789 Count	51 Count
1756517956	194 Count	744 Count	48 Count
1756516276	185 Count	700 Count	46 Count
1756514595	171 Count	661 Count	42 Count
1756512914	159 Count	623 Count	39 Count
1756511233	148 Count	584 Count	36 Count
1756509553	137 Count	535 Count	33 Count
1756507872	127 Count	484 Count	31 Count
1756506191	119 Count	434 Count	29 Count
1756504510	111 Count	393 Count	28 Count
1756502828	104 Count	358 Count	27 Count
1756501398	95 Count	333 Count	26 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)