LY1BWB APRS Track Direct

Mano pozicija Apie ☰

reset

SP2OSA-2 Telemetrija

This is the latest recevied telemetry packets stored in our database for station/object SP2OSA-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1752231498	249 Count	43 Count	43 Count
1752230597	248 Count	43 Count	43 Count
1752229720	247 Count	43 Count	43 Count
1752228819	246 Count	43 Count	43 Count
1752227918	245 Count	43 Count	43 Count
1752227017	244 Count	43 Count	43 Count
1752226116	243 Count	43 Count	43 Count
1752225215	242 Count	43 Count	43 Count
1752224313	241 Count	43 Count	43 Count
1752223412	240 Count	43 Count	43 Count
1752222512	239 Count	43 Count	43 Count
1752221610	238 Count	43 Count	43 Count
1752220709	237 Count	43 Count	43 Count
1752219809	236 Count	43 Count	43 Count
1752218908	235 Count	43 Count	43 Count
1752218007	234 Count	43 Count	43 Count
1752217106	233 Count	43 Count	43 Count
1752216205	232 Count	43 Count	43 Count
1752215304	231 Count	43 Count	43 Count
1752214403	230 Count	43 Count	43 Count
1752213502	229 Count	43 Count	43 Count
1752212601	228 Count	43 Count	43 Count
1752211700	227 Count	43 Count	43 Count
1752210799	226 Count	43 Count	43 Count
1752209898	225 Count	43 Count	43 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)