LY1BWB APRS Track Direct

Mano pozicija Apie ☰

reset

SR2ST-2 Telemetrija

This is the latest recevied telemetry packets stored in our database for station/object SR2ST-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1761732835	596 Count	80 Count	72 Count
1761731154	582 Count	79 Count	71 Count
1761729473	550 Count	72 Count	69 Count
1761727792	527 Count	67 Count	67 Count
1761726111	508 Count	65 Count	65 Count
1761724431	494 Count	63 Count	63 Count
1761722999	481 Count	62 Count	62 Count
1761721318	466 Count	60 Count	60 Count
1761719638	452 Count	58 Count	58 Count
1761717957	437 Count	56 Count	56 Count
1761716276	422 Count	54 Count	54 Count
1761714595	410 Count	53 Count	53 Count
1761712914	395 Count	51 Count	51 Count
1761711234	381 Count	49 Count	49 Count
1761709553	367 Count	47 Count	47 Count
1761707872	353 Count	45 Count	45 Count
1761706191	338 Count	43 Count	43 Count
1761704510	324 Count	41 Count	41 Count
1761702830	310 Count	39 Count	39 Count
1761701399	296 Count	38 Count	38 Count
1761699718	281 Count	36 Count	36 Count
1761698037	266 Count	34 Count	34 Count
1761696356	253 Count	32 Count	32 Count
1761694676	240 Count	31 Count	31 Count
1761692995	227 Count	30 Count	30 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)