LY1BWB APRS Track Direct

Mano pozicija Apie ☰

reset

SQ5STR-11 Telemetrija

This is the latest recevied telemetry packets stored in our database for station/object SQ5STR-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1752230534	60 Count	950 Count
1752229633	59 Count	930 Count
1752228733	58 Count	905 Count
1752227832	57 Count	877 Count
1752226931	56 Count	862 Count
1752226030	55 Count	844 Count
1752225129	54 Count	790 Count
1752224228	53 Count	766 Count
1752223327	52 Count	735 Count
1752222427	51 Count	715 Count
1752221526	50 Count	672 Count
1752220625	49 Count	656 Count
1752219724	48 Count	642 Count
1752218823	47 Count	601 Count
1752217942	45 Count	574 Count
1752217041	44 Count	538 Count
1752216140	43 Count	522 Count
1752215239	42 Count	513 Count
1752214338	41 Count	505 Count
1752213437	40 Count	497 Count
1752212536	39 Count	491 Count
1752211635	38 Count	483 Count
1752210734	37 Count	466 Count
1752209833	36 Count	439 Count
1752208933	35 Count	402 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)