LY1BWB APRS Track Direct

Mano pozicija Apie ☰

reset

SQ5STR-1 Telemetrija

This is the latest recevied telemetry packets stored in our database for station/object SQ5STR-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1753307567	20 Count	740 Count
1753306665	19 Count	723 Count
1753305764	18 Count	708 Count
1753304863	17 Count	690 Count
1753303963	16 Count	674 Count
1753303062	15 Count	653 Count
1753302161	14 Count	633 Count
1753301260	13 Count	573 Count
1753300359	12 Count	533 Count
1753299477	11 Count	445 Count
1753298576	10 Count	415 Count
1753297676	9 Count	389 Count
1753296775	8 Count	360 Count
1753295874	7 Count	332 Count
1753294973	6 Count	307 Count
1753294072	5 Count	280 Count
1753293172	4 Count	235 Count
1753292271	3 Count	210 Count
1753291370	2 Count	150 Count
1753290469	1 Count	56 Count
1753289569	0 Count	26 Count
1753288668	59 Count	1046 Count
1753287767	58 Count	971 Count
1753286866	57 Count	939 Count
1753285965	56 Count	909 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)