LY1BWB APRS Track Direct

Mano pozicija Apie ☰

reset

SR2DTW-10 Telemetrija

This is the latest recevied telemetry packets stored in our database for station/object SR2DTW-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1756541079	51 Count	198 Count	31 Count
1756539398	48 Count	188 Count	29 Count
1756537717	45 Count	175 Count	27 Count
1756536036	43 Count	165 Count	26 Count
1756534355	40 Count	158 Count	24 Count
1756532675	37 Count	141 Count	22 Count
1756531243	30 Count	133 Count	20 Count
1756529562	27 Count	120 Count	18 Count
1756527882	24 Count	108 Count	16 Count
1756526201	22 Count	97 Count	15 Count
1756524520	19 Count	89 Count	13 Count
1756522839	16 Count	70 Count	11 Count
1756521158	13 Count	59 Count	9 Count
1756519477	10 Count	48 Count	7 Count
1756517797	7 Count	35 Count	5 Count
1756516116	4 Count	21 Count	3 Count
1756514435	2 Count	12 Count	2 Count
1756512754	236 Count	1005 Count	140 Count
1756511074	233 Count	994 Count	138 Count
1756509642	226 Count	984 Count	136 Count
1756507961	223 Count	974 Count	134 Count
1756506280	220 Count	963 Count	132 Count
1756504599	218 Count	952 Count	131 Count
1756502919	216 Count	944 Count	130 Count
1756501238	213 Count	930 Count	128 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)