LY1BWB APRS Track Direct

Mano pozicija Apie ☰

reset

SP5JWP-10 Telemetrija

This is the latest recevied telemetry packets stored in our database for station/object SP5JWP-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1753476375	152 Count	986 Count	101 Count
1753474574	147 Count	963 Count	97 Count
1753472773	141 Count	935 Count	93 Count
1753470981	131 Count	904 Count	89 Count
1753469180	126 Count	855 Count	85 Count
1753467379	119 Count	808 Count	81 Count
1753465578	114 Count	747 Count	77 Count
1753463778	107 Count	696 Count	73 Count
1753461977	102 Count	669 Count	69 Count
1753460177	96 Count	644 Count	65 Count
1753458376	90 Count	617 Count	61 Count
1753456575	84 Count	590 Count	57 Count
1753454774	78 Count	565 Count	53 Count
1753452974	73 Count	537 Count	49 Count
1753451173	65 Count	504 Count	45 Count
1753449380	57 Count	471 Count	41 Count
1753447579	51 Count	424 Count	37 Count
1753445778	45 Count	400 Count	33 Count
1753443977	38 Count	313 Count	28 Count
1753442176	32 Count	286 Count	24 Count
1753440375	27 Count	261 Count	20 Count
1753438574	20 Count	200 Count	16 Count
1753436774	15 Count	173 Count	12 Count
1753434973	6 Count	67 Count	5 Count
1753433172	130 Count	1002 Count	93 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)