LY1BWB APRS Track Direct

Mano pozicija Apie ☰

reset

SR2CA-10 Telemetrija

This is the latest recevied telemetry packets stored in our database for station/object SR2CA-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1757051541	72 Count	528 Count	52 Count
1757049860	67 Count	494 Count	48 Count
1757048179	62 Count	465 Count	44 Count
1757046498	60 Count	441 Count	43 Count
1757044818	57 Count	415 Count	41 Count
1757043137	52 Count	387 Count	37 Count
1757041456	48 Count	356 Count	34 Count
1757039775	43 Count	330 Count	30 Count
1757038094	38 Count	290 Count	26 Count
1757036414	32 Count	255 Count	22 Count
1757034989	27 Count	228 Count	21 Count
1757033308	23 Count	187 Count	18 Count
1757031627	19 Count	154 Count	15 Count
1757029946	14 Count	119 Count	11 Count
1757028266	11 Count	90 Count	9 Count
1757026585	7 Count	60 Count	6 Count
1757024904	1 Count	28 Count	1 Count
1757023223	86 Count	1042 Count	55 Count
1757021542	83 Count	1000 Count	53 Count
1757019861	81 Count	962 Count	52 Count
1757018181	78 Count	929 Count	50 Count
1757016500	75 Count	888 Count	48 Count
1757014819	72 Count	849 Count	46 Count
1757013382	66 Count	819 Count	45 Count
1757011701	62 Count	780 Count	42 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)