LY1BWB APRS Track Direct

Mano pozicija Apie ☰

reset

SR2ZXT-10 Telemetrija

This is the latest recevied telemetry packets stored in our database for station/object SR2ZXT-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1745035746	37 Count	555 Count	32 Count
1745033946	32 Count	454 Count	28 Count
1745032145	25 Count	363 Count	22 Count
1745030345	19 Count	259 Count	17 Count
1745028544	12 Count	147 Count	11 Count
1745026749	6 Count	69 Count	6 Count
1745024949	99 Count	1011 Count	85 Count
1745023148	93 Count	976 Count	80 Count
1745021347	86 Count	933 Count	74 Count
1745019547	80 Count	895 Count	69 Count
1745017746	73 Count	851 Count	63 Count
1745015945	67 Count	810 Count	58 Count
1745014145	59 Count	767 Count	51 Count
1745012344	53 Count	727 Count	46 Count
1745010544	46 Count	682 Count	40 Count
1745008743	40 Count	645 Count	35 Count
1745006942	33 Count	597 Count	29 Count
1745005149	27 Count	547 Count	24 Count
1745003349	18 Count	431 Count	16 Count
1745001548	14 Count	302 Count	13 Count
1744999748	8 Count	123 Count	8 Count
1744997947	59 Count	1009 Count	52 Count
1744996146	51 Count	877 Count	45 Count
1744994346	46 Count	776 Count	41 Count
1744992545	42 Count	663 Count	38 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)