LY1BWB APRS Track Direct

Mano pozicija Apie ☰

reset

SP5JWP-10 Telemetrija

This is the latest recevied telemetry packets stored in our database for station/object SP5JWP-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1745035094	122 Count	356 Count	83 Count
1745033300	113 Count	340 Count	79 Count
1745031499	108 Count	323 Count	75 Count
1745029699	102 Count	305 Count	71 Count
1745027898	98 Count	289 Count	68 Count
1745026097	93 Count	270 Count	64 Count
1745024297	88 Count	254 Count	60 Count
1745022496	83 Count	239 Count	56 Count
1745020695	77 Count	224 Count	52 Count
1745018894	72 Count	207 Count	48 Count
1745017094	66 Count	193 Count	44 Count
1745015293	61 Count	180 Count	40 Count
1745013493	54 Count	170 Count	36 Count
1745012639	50 Count	170 Count	36 Count
1745010838	46 Count	153 Count	33 Count
1745009037	42 Count	139 Count	30 Count
1745007237	37 Count	123 Count	26 Count
1745005436	32 Count	106 Count	22 Count
1745003635	28 Count	91 Count	19 Count
1745001835	22 Count	72 Count	15 Count
1745000042	14 Count	50 Count	12 Count
1744998242	9 Count	35 Count	8 Count
1744996441	4 Count	16 Count	4 Count
1744994639	354 Count	1016 Count	247 Count
1744992839	349 Count	999 Count	243 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)