LY1BWB APRS Track Direct

Mano pozicija Apie ☰

reset

SQ2ODE-2 Telemetrija

This is the latest recevied telemetry packets stored in our database for station/object SQ2ODE-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1764646699	511 Count	1000 Count
1764644898	510 Count	999 Count
1764643098	509 Count	998 Count
1764641297	508 Count	997 Count
1764639496	507 Count	996 Count
1764637696	506 Count	995 Count
1764635895	505 Count	994 Count
1764634095	504 Count	993 Count
1764632301	503 Count	992 Count
1764630500	502 Count	991 Count
1764628699	501 Count	990 Count
1764626899	500 Count	989 Count
1764625098	499 Count	988 Count
1764623298	498 Count	987 Count
1764621497	497 Count	986 Count
1764619696	496 Count	985 Count
1764617896	495 Count	984 Count
1764616095	494 Count	983 Count
1764614294	493 Count	982 Count
1764612494	492 Count	981 Count
1764610700	491 Count	980 Count
1764608899	490 Count	979 Count
1764607099	489 Count	978 Count
1764605298	488 Count	977 Count
1764603497	487 Count	976 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)