LY1BWB APRS Track Direct

Mano pozicija Apie ☰

reset

SQ2LXR-1 Telemetrija

This is the latest recevied telemetry packets stored in our database for station/object SQ2LXR-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RX*	Digi*
1764481976	160 Count	61 Count
1764481916	160 Count	61 Count
1764481856	160 Count	61 Count
1764481796	157 Count	60 Count
1764481736	154 Count	59 Count
1764481675	154 Count	59 Count
1764481615	154 Count	59 Count
1764481594	154 Count	59 Count
1764481534	154 Count	59 Count
1764481474	154 Count	59 Count
1764481414	154 Count	59 Count
1764481354	152 Count	58 Count
1764481294	149 Count	57 Count
1764481233	149 Count	57 Count
1764481173	149 Count	57 Count
1764481113	147 Count	56 Count
1764481053	146 Count	56 Count
1764480993	146 Count	56 Count
1764480932	146 Count	56 Count
1764480872	143 Count	55 Count
1764480812	141 Count	54 Count
1764480751	141 Count	54 Count
1764480691	141 Count	54 Count
1764480631	141 Count	54 Count
1764480570	141 Count	54 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)